Dryer Vent Cleaning in Arlington - One Flat Price, Airflow Tested Before and After

Trusted Dryer Vent Cleaning for Arlington Homeowners

A clogged dryer vent does two things at once: it stretches drying time until you’re running every load twice, and it traps hot, lint-heavy air inside a duct that was never built to hold it. Lint is fuel, and a vent packed with it is the chain that lets a small ignition become a house fire. Industry-recognized fire data puts dryer vents among the leading causes of residential fires, which is why this is one of our three core services at Paragon Air Duct Cleaning, not an add-on squeezed in after a duct job. Our technicians have up to 12 years of experience and we can usually reach Arlington homes the same day. Call (844) 787-8766 for a free estimate.

Call (844) 787-8766

Dryer Vent Cleaning Service

Dryer Vent Cleaning Service is the full removal of lint, dust and heat-blocking debris from the duct that runs from your dryer to the outside of the house, plus the blower housing and the exterior hood. You need it when clothes take two cycles to dry, when the top of the dryer feels hot to the touch, when you smell a faint scorched note after a load, or when it has simply been a long stretch since the last cleaning. At Paragon Air Duct Cleaning we run a Rotobrush rotary brush through the full length of the line and pull the loosened material out with a Nikro vacuum rig so nothing settles back into the run. A typical residential cleaning in Arlington runs $99-$250 depending on vent length, how many bends the duct has, and how much buildup we find. Every job is one flat price per system, agreed in writing before we start.

What the Cleaning Actually Removes

Lint is only part of the load. A dryer vent also collects sheet lint that peels off the duct’s interior, construction dust from the day the house was built, and on some Arlington homes, debris blown in through the outside hood. We clear all of it in one pass rather than chasing the surface layer.

Before and After Photos Every Time

This is the trade’s weak spot: you can’t see inside a wall, so some outfits clean half the run and charge for the whole thing. We photograph the inside of the duct and the exterior hood before we start and again when we finish, and those photos are yours. You see exactly what came out of your vent.

Dryer Vent Installation

Dryer Vent Installation is the job of running a new, correctly sized and correctly routed duct from the dryer to an exterior termination point, and it comes up more often in Arlington than people expect. Rigid foil-flex and vinyl kits get run too long, with too many elbows, or with a run that dumps into an attic or crawl space instead of daylight. When the existing route can’t be brought up to standard, we replace it. Dryer Vent Installation in Arlington runs roughly $150-$450 depending on length, how much wall or attic access the route needs, and whether the termination hood is new. You get a written flat price before any work begins.

Rigid Duct Over Flexible Kits

We route with smooth rigid or semi-rigid duct where the space allows it. Flexible corrugated kits are what let lint snag on the interior ridges in the first place, and a smooth run stays clearer far longer between cleanings. Where a short flex transition is unavoidable, we keep it short and supported.

Getting the Termination Right

The outside end matters as much as the inside. We fit a hood with a backdraft damper that closes when the dryer stops, so air, insects and rain stay out, and we keep the termination clear of the ground and clear of anything that could block the flap. A blocked termination makes the whole system work harder.

Dryer Vent Repair

Dryer Vent Repair covers everything that has failed in the run: crushed sections behind the dryer, separated joints, torn flex, a damper flap stuck open, a hood that birds have nested in, or duct that has come loose from the wall boot. You need it when you find lint dust on the laundry floor, when the outside flap never moves, or when a cleaning reveals duct that’s damaged rather than just dirty. This is the reason Paragon is equipped to repair and not only clean. Dryer Vent Repair in Arlington typically runs $120-$350 depending on the part and how much access is required. The written estimate sets the final price before we begin.

Crushed Duct Behind the Dryer

The most common failure we find is the accordion section the dryer was pushed back into. A crushed flex elbow chokes airflow right at the source, which pushes heat and lint back into the machine. We replace that section with a properly supported transition that lets the dryer sit flush without pinching the duct.

Damper and Hood Failures

A damper that hangs open lets hot, humid outside air and pests into the line, and a hood with a broken hinge or a packed screen does the opposite and blocks exhaust. We repair or replace the hood assembly so the flap seats when the dryer cycles off and opens freely when it runs.

Dryer Vent Cleaning Company

A Dryer Vent Cleaning Company is the specialist you bring in when the job needs real equipment rather than a shop vac and a brush on a stick. That distinction matters in Arlington, where a lot of homes have long vent runs through interior walls and second-floor laundry rooms, and a short brush simply can’t reach the far end. Paragon Air Duct Cleaning approaches dryer vents as a fire-safety service, with Rotobrush rotary tooling, Nikro high-powered vacuum, and Abatement Technologies equipment on hand for heavier contamination. Pricing for a full residential cleaning is $99-$250, one flat price per system. We can also work with your insurer if a claim is involved.

Equipment That Reaches the Whole Run

The rotary brush is driven by a cable that follows the duct around bends while the vacuum holds the loosened material under negative pressure. That combination is what separates a real cleaning from a surface pass, particularly on a run that turns three or four times before it reaches daylight.

One Flat Price, Not a Per-Vent Teaser

The bait-and-switch pattern in this trade is a low advertised number that grows once the technician is standing in your laundry room. We don’t price dryer vents that way. You get one flat price for the whole system, written down before work starts, and it doesn’t move because the job turned out to be dirtier than expected.

Dryer Vent Inspection

Dryer Vent Inspection is a visual and airflow assessment of the entire vent path, from the dryer connection to the outside termination, and it’s the right first step if you’re not sure whether you need cleaning, repair, or nothing at all. You need one when you’re buying a home in Arlington, when a home inspection flagged the vent, when the dryer is drying poorly and you can’t tell why, or when it’s been years and you have no record of the last cleaning. We check the full route, test airflow, and photograph what we find. For a dryer vent cleaning, inspection is included as part of the visit. Call (844) 787-8766 to schedule.

What the Inspection Covers

We look at the transition behind the dryer, every accessible joint and support along the run, the wall boot, and the exterior hood. Airflow is measured at the termination, since a weak exhaust reading tells us more about a blockage than a visual pass ever will. You get a plain explanation of what we found.

When Cleaning Isn’t the Answer

Some inspections end with a repair recommendation instead of a cleaning, and we’ll tell you when that’s the case. Crushed duct, a failed damper or a route that violates the dryer manufacturer’s length limits won’t be fixed by brushing it out. Knowing which problem you have stops you paying for the wrong service.

Commercial Dryer Vent Cleaning

Commercial Dryer Vent Cleaning handles the multi-unit laundry rooms, coin-operated banks and on-premises laundry setups that run far more loads per day than any house does. It’s needed on a schedule, not on a hunch, because a commercial bank of dryers can load a vent line with lint in weeks that would take a household a year. Paragon Air Duct Cleaning brings the same professional-grade equipment to these jobs, scaled to the run size, and documents what we removed. Commercial pricing is quoted per building based on the number of dryer connections and total duct length. Call for a free estimate.

Higher Load Counts, Faster Buildup

Every commercial dryer cycle pushes lint into the line, and a bank running dozens of loads a day fills a duct quickly. What looks like a slow-drying machine is often a vent line that’s already restricted. Scheduling on load volume rather than calendar guesswork keeps the equipment running at its rated capacity.

Keeping Records for Property Managers

Property managers and facility supervisors usually need documentation, not just a truck visit. We photograph the duct before and after and give you a clear record of the condition and the work performed. That record is what supports a maintenance schedule and satisfies a fire-safety review.

Brands We Service

We service Honeywell and Aprilaire air-quality equipment alongside the duct system itself, which matters because dryer vent performance is tied to how the whole air-handling setup in the house behaves. A home with a Honeywell control and filtration setup has a return-air path that affects overall pressure in the home, and we read the full system rather than the vent in isolation. We know where this equipment wears and what it needs.

On the cleaning side, we run Rotobrush rotary-brush systems and Nikro high-powered vacuum rigs, with Abatement Technologies equipment available when a job involves heavier contamination. We’re not a dealer for any brand and we don’t claim to stock factory parts. Whether you have Honeywell, Aprilaire, Guardsman or any other make, we can help.

Signs You Need a Pro Right Now

• Clothes take two cycles to dry. A dryer that used to finish a load in 45 minutes and now needs 90 is fighting a restricted vent. The machine is working harder than it should, and the heat has nowhere to go.
• The dryer body runs hot to the touch. Heat building on the cabinet instead of venting outside points to a blockage somewhere in the run. That’s a safety issue before it’s a performance issue.
• You smell a scorched note after a load. A faint burning smell is lint getting hot, not a machine wearing in. Stop using the dryer until it’s checked and cleared.
• Lint is collecting behind or under the dryer. Visible lint around the machine usually means the connection has come loose or the transition is torn. It also means lint is escaping somewhere it shouldn’t.
• The outside damper never moves. If the flap on the exterior hood stays shut while the dryer runs, exhaust isn’t reaching daylight. A stuck flap, a nest or a crushed run will all produce the same symptom.

Our Process, Step by Step

1. 1
   We inspect the full run before touching it. The transition behind the dryer, every accessible joint, the wall boot and the exterior hood all get checked, and airflow is measured at the termination. Getting a baseline tells us whether we’re cleaning, repairing or both.
2. 2
   We photograph the starting condition. Pictures of the duct interior and the hood before work begins give you a real record of what we’re dealing with. It’s the same set you compare against when we finish.
3. 3
   We run the rotary brush through the whole length. A Rotobrush cable-driven brush follows the bends while a Nikro vacuum holds the duct under negative pressure, so loosened lint and dust are captured rather than pushed into the laundry room. Heavier contamination gets the Abatement Technologies equipment.
4. 4
   We clear the dryer housing and the termination. The blower housing behind the drum and the exterior hood collect material the brush doesn’t reach from inside the duct. Both come apart far enough to clear properly.
5. 5
   We re-test airflow and show you the result. Airflow is measured again at the hood, the before-and-after photos are yours, and we tell you plainly if we found a repair that should be handled. If one of our Air Duct Repair jobs is the better fix, we’ll say so.

How Much Does Dryer Vent Cleaning Cost in Arlington?

Our Service Area Near Arlington

We serve Arlington and the surrounding cities, including Pantego, Edgecliff Village, The Homesteads, Westworth Village, Kennedale, Forest Hill, Mansfield, Richland Hills and Hurst. Response times are typically same-day for the closer neighborhoods and next-opening for the outer ones. For the same service on the west side, see our dryer vent cleaning in Pantego, and to the south, our dryer vent cleaning in Edgecliff Village.

Frequently Asked Questions About Dryer Vent Cleaning in Arlington

Schedule Your Dryer Vent Cleaning Service in Arlington Today

If your dryer is running longer, the cabinet feels hot, or you can’t remember the last cleaning, don’t wait on it. Call Paragon Air Duct Cleaning at (844) 787-8766. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. You get a free, no-obligation estimate, one flat price per system in writing, and before-and-after photos of your own vent. For the wider picture on your home’s ductwork, see Paragon Air Duct Cleaning.

Written by the team at Paragon Air Duct Cleaning.