Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Air Duct Repair for Arlington Homeowners
Leaky, torn, or sagging ductwork is the reason a house in Arlington can feel stuffy in one room and cold in the next, no matter what the thermostat says. You’re paying to condition air that never reaches the register. We fix that at the source. Our technicians have up to 12 years of experience working on duct systems across Tarrant County, and they carry professional-grade equipment from Rotobrush and Nikro rather than consumer tools. If you’ve had an HVAC inspection flag a problem, or you’re tired of guessing why one bedroom never cools, we can take a look. We don’t just clean – we repair. Call (844) 787-8766 and we’ll schedule a free estimate. Same-day repair is often possible, with fast dispatch from 7am to 7pm, Sunday through Friday.
HVAC Duct Installation
HVAC Duct Installation is the full build-out of a duct system, and we handle it as a standalone service separate from routine cleaning. Homeowners usually need it after a major remodel, an addition to the house, or when an older system was laid out poorly from the start and no amount of patching will fix the airflow. Our technicians have up to 12 years of experience with this kind of work, and we use Nikro and Abatement Technologies equipment to verify airflow and contamination before we close anything up. For a typical residential install in Arlington, you’re looking at roughly $2,500 to $8,000 depending on square footage, the number of registers, and whether we’re replacing flex with rigid ductwork. We’ll give you a free written estimate with the full breakdown before any work begins.
Flexible and Rigid Duct Systems
Flex duct is common in Texas attics and easy to run, but it needs proper support and slack or it collapses. Rigid metal lasts longer and moves air more predictably, though it takes more planning and fitting. We’ll walk you through the tradeoffs for your specific house before recommending one.
Attic and Crawlspace Routing
Attics here get brutally hot in summer, which shortens the life of duct insulation and seals. We route and insulate to keep attic heat from bleeding into the supply run. Crawlspace routing gets the same attention to moisture and support.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Air Duct Replacement
Air Duct Replacement is the removal and rebuilding of ductwork that’s past the point of repair, and we treat it as a distinct job from a patch or a clean. If your ducts are old, crushed in multiple spots, or contaminated throughout, replacing them is more cost-effective than chasing leak after leak. We use Nikro and Rotobrush equipment to assess the full system before quoting, then replace with properly sized and sealed ductwork designed for your HVAC capacity. In Arlington, a whole-home replacement typically runs $2,000 to $6,500. The written estimate locks the price in before we start, so there are no surprises once the work is underway.
Partial and Whole-Home Replacement
Sometimes only one branch or one trunk needs replacing, and that’s a smaller, faster job. Other times the duct design itself is the problem and a full rebuild makes more sense. We’ll tell you honestly which applies to your system.
Choosing the Right Duct Material
The right material depends on where the duct runs, how accessible it is, and what your HVAC can handle. R-6 and R-8 insulated flex is common for attic runs, while rigid or metal-lined sections work better where durability matters. We match material to the actual conditions, not to what’s easiest to install.
Ductwork Repair
Ductwork Repair is fixing the specific damage that’s causing pressure loss – gaps at the joints, tears in flex duct, disconnected runs, or sections that have collapsed under the weight of insulation. We find and fix these problems rather than just cleaning around them, which is the difference between a temporary fix and a lasting one. Our technicians have up to 12 years of experience diagnosing duct leaks, and they use Rotobrush rotary-brush tools and Nikro vacuum rigs to confirm what a leak test shows. Typical ductwork repair in Arlington runs about $300 to $1,200 depending on how many spots need attention and how accessible they are. We’ll give you a free written estimate that spells out exactly what gets fixed and what it costs before we start.
Sealing and Reconnecting Runs
Disconnected joints are one of the most common problems we see, and they’re also one of the easiest to fix once located. We re-seal with mastic or approved tape, not the metal-backed “duct tape” that fails in Texas heat. Reconnecting a separated run often restores airflow to an entire room.
Locating the Source of the Leak
Guessing wastes money. A proper static-pressure and airflow check points us to the leak instead of a random search in the attic. We test before and after so you have proof the repair worked.
Duct Replacement
Duct Replacement covers swapping out one section or a whole run when the duct itself is failing beyond repair, rather than just sealing a small spot. It comes up when ductwork has been crushed by contractors or storage, or when it’s so leaky that the system can’t hold pressure, or when it’s the wrong size for the air handler it serves. We handle it using the same professional equipment we use across cleaning and repair, and the work is scoped in a free written estimate so the cost is settled before anything moves. In Arlington, duct replacement runs roughly $1,200 to $4,500 for a single run, or higher for whole-home. Full replacements go up to $6,500.
Single-Run Replacements
Not every failing run means a full replacement. Replacing just the damaged branch keeps cost down and gets the room back to functioning airflow. This is often the sensible option when the rest of the system still holds pressure.
When Repair No Longer Makes Sense
If a duct has failed in three or more places, patching it is just postponing the inevitable. We’ll tell you when replacement costs less than repeated repairs. The written estimate makes that comparison clear.
Ductwork Installation
Ductwork Installation means building out new duct runs, whether for an added room, a new air handler, or a major remodel where the existing layout no longer serves the house. Installation is planning-heavy work: register placement, static pressure, and room-by-room load all get considered before a single piece of duct is cut. Our technicians handle this with Nikro and Abatement Technologies equipment on site, and we size the system to your HVAC rather than the other way around. In Arlington, ductwork installation typically runs $2,500 to $7,500 depending on square footage and complexity. The free estimate will show you the design and the cost before any work begins.
Planning the Layout for Airflow
Airflow planning is where most installations succeed or fail. Registers need to be positioned so each room gets what it needs without starving the rest of the system. We map the design against the air handler’s capacity before installation starts.
Sealing and Insulating New Runs
New duct doesn’t come pre-sealed at the joints, and unsealed joints leak a meaningful share of the air moving through them. We seal every connection and insulate runs that pass through unconditioned attic space. That’s the difference between a duct system that’s installed and one that’s installed right.
Brands We Service
We work on Honeywell and Aprilaire air-quality components with real familiarity – the humidifiers, dehumidifiers, and zone controls these brands put into Texas homes. We know where they wear out and how they interact with the rest of the HVAC system. Guardsman filters and mesh components turn up often too, and we understand how they fit into the air stream so replacement and repair don’t compromise filtration.
Our technicians also deal with Rotobrush and Nikro equipment in the field every week, so the diagnostic tools and cleaning rigs those brands produce are part of how we work. If your home has Abatement Technologies air-quality equipment installed, we can service around it and confirm it isn’t contributing to the problem. Whether you have Honeywell, Aprilaire, Guardsman, or any other make, we can help.
See the difference
Before
After
Before
After
Before
AfterSigns You Need a Pro Right Now
- Rooms that never cool or heat evenly. A room that stays stuffy or cold while the rest of the house is fine usually means a broken or disconnected run. Small problems become larger when the system runs overtime trying to compensate.
- Higher energy bills with the same usage. If your habits haven’t changed but the bill has, leaking ducts are a likely culprit. You’re paying to condition air that’s escaping into the attic.
- Dust blowing from the registers after a clean. Duct debris that comes back quickly often points to a gap pulling in attic dust. That’s a repair issue, not a cleaning one.
- Visible tears, sagging, or crushed sections. Ducts in a hot Texas attic take a beating. If you can see the damage, the system has been losing air for a while.
- A whistling or hissing sound at the vents. Noise at the register usually signals a pressure imbalance from a leak or an undersized run. It’s worth a diagnostic look before the compressor starts working harder than it should.
Our Process, Step by Step
- 1
Free in-home estimate. We start with a walkthrough of your system – where the ducts run, what’s accessible, what your HVAC is rated for. No upsell, no pressure, just a written scope and a flat price per system before any work starts.
- 2
Airflow and pressure assessment. We use static-pressure and airflow testing to find the actual leak or failure point, not a guess based on symptoms. This is the step most companies skip, and it’s why we don’t quote blind.
- 3
Targeted repair or replacement. Depending on what the assessment shows, we seal, reconnect, or replace individual sections. If the problem is systemic, we’ll show you why a larger scope makes sense instead of patching.
- 4
Cleaning and verification after the repair. Once the structural work is done, we clean and photo-document the duct runs so you can see the before-and-after. Professional-grade equipment from Rotobrush and Nikro is used for this stage, not consumer tools.
- 5
Final walkthrough and written record. We show you the photos, walk you through what changed, and leave you with the written scope and the documented results. If anything needs a follow-up, it gets scheduled before we leave.
How Much Does Air Duct Repair Cost in Arlington?
Air duct repair in Arlington typically runs $300 to $1,200 for most repair jobs, depending on how many leaks or damaged runs need attention and how accessible they are. Here’s how the ranges break down: a single spot seal or reconnected run is usually at the low end, around $300 to $500. Multiple repairs or several separated runs usually fall in the $600 to $900 range. Larger repairs involving crushed sections or a partly failed system can land between $900 and $1,200.
Several things move the number. Ducts in a hot attic are harder to reach, and difficult routing adds labor. The number and location of leaks matters too. If a repair turns out to be too extensive, or if two or more failures are found, we’ll quote replacement instead of a patch – and explain why.
How to avoid overpaying: get the whole scope in writing, insist on a flat price per system rather than per-vent pricing, and ask for before-and-after photos when the work is done. Those three steps protect you from the industry’s common bait-and-switch problem, where a low teaser price turns into a much larger invoice. Our free estimate includes the full scope, the flat price, and what’s covered. Call (844) 787-8766 for an exact quote.
Our Service Area Near Arlington
We work throughout Arlington and the surrounding cities, with technicians who can reach most areas in Tarrant County the same day a booking is confirmed. That includes Pantego, Edgecliff Village, Kennedale, Forest Hill, Mansfield, Richland Hills, Hurst, The Homesteads, and Westworth Village. Familiarity with each area’s housing stock and HVAC setups helps us quote more accurately and work more efficiently. If you’re outside these cities, call and we’ll confirm whether we can reach you.
Serving Arlington, TX – Our Local Coverage Area
We serve Arlington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Air Duct Repair in Arlington
Air duct repair is fixing the physical damage to your ductwork – leaks, disconnected joints, tears, crushed sections, or sagging runs – so the system can move air properly again. It’s separate from cleaning, which removes debris but doesn’t address structural problems. Our air duct cleaning service handles the cleaning side, and repair handles the structural side. Together they fix both the symptom and the cause.
Most repair jobs in Arlington take half a day to a full day, depending on how many leaks or runs need work and how accessible the ducts are. A single sealed run might take an hour or two. A larger multi-run repair that requires attic access and more extensive sealing often runs a full day. We’ll give a realistic timeline with your written estimate.
Typical range is $300 to $1,200 for most repair jobs, with the written estimate setting the final price. Factors include the number of leaks, accessibility, and whether any section needs replacing rather than repairing. Call (844) 787-8766 for an exact quote – estimates are free.
Yes, we use Rotobrush and Nikro equipment as part of our own diagnostic and repair work, so we’re deeply familiar with how both perform. We also service Honeywell, Aprilaire, Guardsman, and Abatement Technologies equipment in the same homes. If your system uses a brand we haven’t listed, call and we’ll confirm whether we can work on it.
Same-day repair is often possible in Arlington when the job is booked early. We answer 24/7, and fast dispatch from 7am to 7pm runs Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Saturday is closed, so a Saturday call is booked into Sunday.
We stand behind the repairs we make, and the written estimate spells out what’s covered and for how long. We don’t make blanket guarantees we can’t define, so the scope and any warranty terms are documented before work starts. If something we fixed isn’t holding, call us and we’ll take a look.
Clear reasonable access to your attic hatch, air handler, and the registers we may need to reach, and let us know if anything is fragile or blocked. If you have pets, secure them during the visit. Beyond that, no special preparation is needed – we bring the equipment and the drop cloths.
Schedule Your Air Duct Repair Service in Arlington Today
Whether you’re dealing with uneven cooling, a known leak, or just got an inspection flag, the next step is a free estimate. Call (844) 787-8766 to schedule. Our technicians have up to 12 years of experience, we use professional-grade equipment every job, and you’ll get a flat price per system in writing before we start. No bait-and-switch, no per-vent pricing, no surprises. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Paragon Air Duct Cleaning.